WATEX WRO200 reverse osmosis system 200 lph

WATEX WRO200 reverse osmosis system

Advantages: extra compact, high quality performance, competitive price

Reverse osmosis system for brackish water with flow rate 200-250 liters/hour.
WATEX WRO series reverse osmosis systems are used for low mineralised water (up to 4000 ppm) with different flow rates.

Reverse osmosis system purify water from 99.2% of salts, pyrogenic substances and microorganisms.
Permeate quality and flow rate depends on intake water salt concentration, temperature, applied pressure, membrane selection and pretreatment.

Quality and operation control system:

• On-line conductivity meter 0-500 microS/cm
• Inlet water low pressure switch and alarm
• Permeate high pressure switch
• Pressure indicators (inlet, after pump, concentrate)
• Permeate flow meter
• Concentrate drain flow regulation
• Pump pressure regulation valve
• Water leakage alarm and shut-off
• High conductivity alarm
• Automatic/manual flushing system
• Recirculation/recovery regulation

Notes:

• Data based on following parameters: 1500 mg/l NaCl solution at 10 bars, 5-9^oC, Salt rejection 99.2%, SDI<3 brackish and low-mineralized water
• Pretreatment required: sediment filtration, iron removal, softening or antiscalant dosing, adsorption by activated carbon if chlorine presence
• Clean water reservoir minimum 200 liters required after reverse osmosis system

Optional features

• Antiscalant dosing system
• PLC operating controller
• Temperature switch
• Stainless steel pipes and fittings (AISI304, AISI316)
• Pretreatment built-in
• Dry-run protection of the reverse osmosis pump